
Commutator Cleaning Pen
For fast and easy cleaning and polishing of your 12T MudBoss commutator.
- Over 20,000 glass fibers in pen point
- Removes carbon tracking for improved power
- Provides a smooth, flawless finish
- Includes extra pen point in rear cap
- Tip cleans up with Simple Green, alcohol etc.
- PLEASE read the safety instructions bottom of page
- The fibers can be harmful
Cleaning Instructions Below
You can use the TKO commutator cleaning pen two ways. The second being the fastest and most efficient.
First, by hand:
-Add a large pinion to the shaft for easier turning of armature.
-Twist rear of pen CW to bring the element out about 18MM.
-Lay the motor on its side. One of the openings that is not impeded by a brush arm should be pointing straight up. Carefully insert the element and rest it on the comm surface.
-Apply light pressure and turn the armature CCW until the desired result is achieved.
-Spray out the comm and oil the bushings.
-Ready to run.
Second, using a drill:
-Chuck the 12T arm in a variable speed drill set to turn CCW. Twist rear of pen CW to bring the element out about 18MM.
-Lay the drill and motor on its side One of the openings that is not impeded by a brush arm should be pointing straight up. Carefully insert the element and rest it on the comm surface.
-Apply light pressure and slowly rotate the armature CCW with the drill. Constantly check your work until desired result is achieved.
-Spray out the comm and oil the bushings.
-Ready to run.
Safety Instructions/Very important
-Do not touch bristles.
-Keep out of reach of children.
-In use bristles can & will break off.
-Wipe work area with a damp paper towel to collect any broken bristles.
-Always retract bristles when not in use.
-If hands or fingers come in contact do not touch your eyes. Thoroughly wash and inspect hands before proceeding.